First Print Steps 1-5 - Support

Step 3: Projector Calibration

Completed by B9Creations

Your B9Creator's projector has already been calibrated. Please run through the steps verifying your zoom wheel and focus ring are properly set.
**Please do not move the projector. If you are experiencing any difficulty verifying the calibration, please, contact the factory.**

Step 4: Build Table Calibration

Completed by B9Creations

Your B9Creator's build table is already calibrated. Please run through the steps verifying the build table is resting flat against the PDMS in your VAT.

First Print

Step 1: Hardware Assembly

Step 2: Software Installation and Printer Set Up

Software Downloads -

Step 3: Projector Calibration

Step 4: Build Table Calibration

Step 5: Printer Fine Tuning Process

Step 6: Your First Print