TAJS wrote:Furthermore, this forum has turned into a ghost town, the support portal has obviously taken its place. I asked a simple question back on Feb 1st and no one commented or answered. I simply wanted to know if you guys turn off your printer each night...at this pont I don't really care what you guys do...
I remember seeing that I thought I answered yes to it but apparently I was just think it. LOL
I had to search for it and found the question as part of the original question on the 31st.
I think the reason it's a "ghost town" here as far as the B9 Core goes is because it just doesn't have many problems and if it does
the warrantee and the customer service is all supported by the portal. Unlike the 1.1 and 1.2HD all the basic problems or new ideas using them have
been eliminated with the Core. We can offer our suggestions but really like I had mentioned to you was to turn it off and back on after waiting a few minutes and that is the basic fix to start with for anything with a motherboard LOL
But I am sure what ever you need done with this it will be taken care of by the B9 folks. We can't make any changes to the machine other than enter custom settings to maybe use other resins not provided by B9.
You have always sent us pictures of your fantastic jewelry and as always then ROCK!!
Don't be too hard on us we value all your input.
As for my answer about turning it off at night?
I turn mine off when it is not being used all the time. I only turn it on when I am going to use it and that is day or night.
I figure it is safer off than on in case of a power outage and surge.