Cannot get the '-' to print on the 'F-' in calibration print. (1.1)

Any and all 3D Printing related topics
Amblix172
B9 Maker
B9 Maker
Posts: 23

Cannot get the '-' to print on the 'F-' in calibration print. (1.1)

Post#1 » Sat Aug 12, 2017 3:26 pm

Hi Everyone,

I ran into an issue where my supports seem to be warping (maybe from being 3" long and thin?) Or when growing something off a support, the resin was able to make the supports bend in some cases simply from the back and forth of the vat.

Anyhow, I went to recalibrate (factory settings as well) and noticed I cannot get the '-' to print on the 'F-' in calibration print. Everything else looks okay (though I have not measured with a caliper yet)

Here is a picture. Everything looks to be 'in focus' from my end and letters are nice and clear.

20170812_135001.jpg


Which setting would be responsible for this? Added appreciation if you know why supports would bend :)

Thank you!

-Tim

User avatar
Robert Howle
B9 Creator
B9 Creator
Posts: 6355

Re: Cannot get the '-' to print on the 'F-' in calibration print. (1.1)

Post#2 » Sat Aug 12, 2017 5:06 pm

Have u watched the videos on calibration. There is one to analyze the calibration print. Go to "Support" top of page. Scroll down to register for "Support Portal" to access videos.

Robert Howle
Dance like nobody's watching!

Return to “3D Printing”

Who is online

Users browsing this forum: No registered users and 0 guests

Creations
X CLOSE
Discover the Creations
made 
by customers and partners.

more on

Close Menu Shop Forum