Hi people! After 633 Hrs of work my lamp projector died
so the green power led blinking continuosly. I replaced the old bulb with a new one buyed on internet 76 euro, as spare lamps for the D 912 Hd projectors. Outside the lamps look the same but the id numbers on the lamps are differents: the old one is 3246L78P Re6
the new one is 6391N33T RK4 So now the green power light doesn't blink on the print start but after 1o/15 layers the print stop and appear one error message to check the connection etc. etc.
I wonder this issue could depend by the different id on the lamp?
in attached the old and new lamps pics
somebody told me that the problem is that the projector born to work in horizontal position, instead it does work in vertical and that cause overheating problem and for that the ceramic back protection of my old lamp broken just after only 633 hrs of works. Is it possible
The tragics is that now I can't work what do you suggest me?
Thanks and Ciao Sergio