Calibration problem

Hardware issues, problems and solutions
romannysh@gmail.com
Newbie
Newbie
Posts: 5

Calibration problem

Post#1 » Fri Jul 14, 2017 8:04 am

Hi guys, i"m having some problems with my projector tuning. I have printer about 30 calibrating samples by folowing b9 projector-tuning instruction and still have no any good results. I have attached two pictures of the sample that i printed with default setting, located on the lable inside the printer. As you can see on the picture, one of the side squares doesn"t fully print as well as B9 creator word. Any idea what i can do?
Attachments
unnamed.jpg
unnamed (1).jpg

Aaron RMW
B9 Maker
B9 Maker
Posts: 28

Re: Calibration problem

Post#2 » Fri Jul 14, 2017 11:16 am

looks like adjusting buth fade and balance up should do the trick, what are your squares measuring out to? also do you have any fogging on the PDMS?

Return to “Troubleshooting”

Who is online

Users browsing this forum: No registered users and 0 guests

Creations
X CLOSE
Discover the Creations
made 
by customers and partners.

more on

Close Menu Products Forum