Page 2 of 2

Re: Grid perfect but Print fails

Posted: Sun Dec 18, 2016 10:22 pm
by V Jewels
Hi Robert,
Pls send a pre sliced file, no problems with 30xy & 30z.
Rishi

Re: Grid perfect but Print fails

Posted: Sun Dec 18, 2016 11:16 pm
by Robert Howle
Very busy with christmas work. But will try to send Monday.

Send me your email

howlere@gmail.com

Robert

Re: Grid perfect but Print fails

Posted: Mon Jan 02, 2017 3:49 am
by V Jewels
Hi Robert,
Pls send me a file to print, as am unable to print... Thanks...

Re: Grid perfect but Print fails

Posted: Mon Jan 02, 2017 11:02 am
by Robert Howle
you need to print the calibration file for your xy and z I will send the 30 and 30 file.

Robert

Re: Grid perfect but Print fails

Posted: Tue Jan 10, 2017 1:06 am
by V Jewels
Hi, my machine has been dead for months now.... can anyone pls help me...
Am able to print the grid perfect.... images uploaded in this thread already... but
none of the pcs are getting printed...
Pls help.

Re: Grid perfect but Print fails

Posted: Tue Jan 10, 2017 1:25 pm
by akgold
V Jewels wrote:Hi, my machine has been dead for months now.... can anyone pls help me...
Am able to print the grid perfect.... images uploaded in this thread already... but
none of the pcs are getting printed...
Pls help.


Where are you located?

Re: Grid perfect but Print fails

Posted: Tue Jan 10, 2017 9:55 pm
by V Jewels
New Delhi, India

Re: Grid perfect but Print fails

Posted: Wed Jan 11, 2017 1:13 am
by mikej
If the calibration file prints OK but the models fail to grow from supports it could be an indication that the MSM is still a bit too low or the image is not sharply focused.

Re: Grid perfect but Print fails

Posted: Wed Jan 11, 2017 8:40 am
by Metalcaster
Could also be the resin ... if you don't shake it really hard when it is new and you just use it without shaking, you may end up with a weaker resin... First Raise your MSM a little as Mike suggested ...if that does not work enough, try fresh very well shaken resin. If the fresh resin works, then add a little bit of the old resin to fresh resin so you can use it up.
I think the msm will probably do it.